News
NEWS
Precautions for pin jack connectors?
When connecting the socket of the pin socket, it is suggested that everyone must also observe whether the lock buckle is buckled, and then pay special attention to not allowing oil and water to enter the socket when overhauling the waterproof connector. Otherwise, it must be cleaned and reconnected after drying. The correct operation of the pin is as follows.
WillPin jackIt is suggested that everyone must also observe whether the lock catch is buckled, and then pay special attention not to allow oil and water to enter the socket when overhauling the waterproof connector. Otherwise, it needs to be cleaned and it can only be reconnected after drying. The correct operation of the pin is as follows.
When using various pin jack testing instruments, first understand their working principles and working conditions, and unreasonable use is strictly prohibited. Therefore, it is also recommended that you confirm whether the test instrument you are using is normal before measuring. In addition, when measuring voltage and current, choose the appropriate measurement range to avoid damage to the instrument. Therefore, the pin jack is used to measure the voltage with the correct gear. In addition, the product also avoids the hard bending and bending of the wiring harness during use; of course, the pin socket should be as far away from the moving parts as possible to prevent breakage and wear; the purpose of this is to avoid contact with sharp metal. Keep away from oil and water as much as possible; attention should also be paid to keep away from high-temperature parts (such as engine blocks). Therefore, when using the pin, if the wire or wire harness is found to be worn, it should be wrapped or replaced immediately, and the wire harness should be fixed in a position where it will not be worn. As the main product of our factory, thanks to the strong support of new and old customers, while ensuring the reliability of product quality, we also benefit our customers. If you have any technical problems related to the product, you can come here at any time to consult.
The pin jacks shall also be terminated and checked in strict accordance with the corresponding termination specifications or requirements, and terminated according to the corresponding contact number. The thickness of the insulation between the selected cable and the wire should match the distance between the contacts, and the cable core should match the terminals of the contacts. And it is forbidden to cross and parallel processing between the contact crimping holes; especially when the product is welded, the electric soldering iron of corresponding power should be selected according to the diameter of the bare wire, and the welding time of each contact point should not exceed 5S. Be careful not to let the flux penetrate into the insulator, so as not to reduce the insulation resistance of the product; in addition, check the model, code, serial number, plug position and direction of the pin socket to meet the requirements of design and process documents; In addition, we also need to ensure that the tail cover is not loose and the binding port does not fall off; the wire harness or wire at the tail door is not bent, and the outer skin is not damaged; especially the grounding wire of the part of the shielding shell is not broken, the welded parts connected to the housing are not loose; the pin socket housing and the butt joint are free of deformation, cracks, thread wear, loose fasteners or defects, and the coating is not peeled off; the locking device should be intact.
The content of the above article is a note on the pin jack connector introduced by the editor. If you didn't know before, you can come and see it now. The next issue will also tell you about the knowledge points related to it. Remember to watch.
Key words:
Related News